Tuning Fork Level Switch For Solid

Power: 20~60VDC 20~250VDC 50/60Hz
Power on time: 2 second when put into materials
Environment temperature: -40~+70℃
Storage temperature: -40~+85℃
Fluid temperature: -40~+150℃
Operate pressure: -1~+40bar
Suitable Medium: Powder and granules =10mm，density>0.1g/cm; Liquid, viscosity = 10000mm2/s, density>0.7g/cm³
Connection method: G1-1/2〞 G1〞
Electrical connection: M12×P1.0 connector
Housing material: ABS aluminum alloy
Fork material: Stainless steel S304/SS316
Output: Relay output，AC250V/4A,DC60V/4A; open-collector gate（NPN）output, minus 400mA; Open collector（PNP）output, minus 400mA
Power consumption: DC power, 3W Max, AC power 15W Max

Tuning fork level switch for solid, vibrating rod level switch Tuning Fork Switch vibrates to tuning fork by piezoelectric crystal and inherent frequency of tuning fork.It can monitor continuously to the change of frequency.
When the tuning fork switch is used for low alarm (or low position control), the medium in the vessel is discharged downward passing through the tuning fork.
When it is lower than the specific location and change the inherent frequency, this change is detected by electronic component, the output state is shifted; when it is used for high alarm (or high position control), the medium in the vessel go upward and contact with tuning fork which can shift the output state. changes, these changes are detected by the intelligent circuit, and converts it into a switch signal.

Tuning fork level switch Application:
Whatever feed,mud and drike or pulp,glue and dye.the level switch is suitable
Water, mineral water
Waste water, sewage, slurry, acid alkali solution
Beer, beer starter culture, juice, beverage
Paper pule, glue,dye,solid power and other similar good mobility materials
Diesel and other similar dangerous liquids/ hazardous conditions

Features:
High adaptation: no influence on electrical parameter and density of medium, suitable for various conditions. Scaling ,stir, turbulent flow, bubble ,vibration, middle viscosity, high pressure, high temperature etc.
No calibration: no need for calibration on spot since no impact on electrical parameter and density of medium
Maintenance-free: no moving parts, no need to maintain after installation.
Various Power supply: he vibrating fork level switch is 20~250VAC, 20~60VDC,Suitable for all Power supply place.
Various Connection: The level switch with flange and thread connection for you reference.